User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Introduction ________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 14 BM210012WT27
Integrator Developers Kit
Wavenet has made available an Integrator Developers Kit which
contains all the components necessary to get an evaluation and
development platform up and running in the shortest possible time. The
Developers Kit contains the following components
Boomer-II Modem Test Jig
Power Cable
RS-232 Serial Cable
MMCX to SMA antenna adaptor cable
800 MHz (blue tip) or 900 MHz (red tip) ¼ wave whip antenna
Flexible Printed Circuit (FPC) connector strips (5 pieces)
FPC connectors (5 pieces)
CDROM containing Software Developers Kit (SDK) and
Integrator's Guide/User Manual
Host Requirements
The minimum system requirements of the host interface PC in order to
utilise the Integrator Developers Kit are:
Intel compatible Pentium computer or higher
Windows 98 or later
16MB RAM (memory) minimum, 32MB recommended
1MB available hard disk space
9-pin serial Port using a 16550 UART
3.5-inch Disk Drive
CD-ROM drive