User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Appendix C – Sample Programs________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 166 BM210012WT27
The Settings tab displays the modems current profile (i.e. Channel list,
RD –Lap version, etc), whether the modem is on or off, the modems
power save mode, and (if supported), its vibrator mode.
The Status tab displays the modem’s current channel (if registered) and
its RSSI level. If the device is not registered, it will be in scan mode,
scanning the channels from the channel list in its current profile.
The Versions tab displays the devices LLI, serial number, hardware
platform and software version.