User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 32 BM210012WT27
The modem utilises connector part number 803-30-T-U from A-Point,
however, connector equivalents such as F006-52893 from Molex as
shown below, may also be used in the host device or terminal.
Molex FPC Connector F006-52893
Pin 1 of the connector is adjacent to the LED window and its location
is shown below.
Data Interface Connector and Pin Numbering
The pin assignment of the Data Interface Connectors is shown in the
following table.
Pin 1
20.4mm
14.5mm
14.5mm