User's Manual

Testing ___________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 56 BM210012WT27
Exploring the Boomer II Test Jig
The test jig comprises the following components:
On / Off switch Switches the power to the test jig on or off.
DC Jack Provides power to the test jig. (3.8V)
DIP Switch 8-way DIP switch used to configure the test jig.
The following table shows the DIP switch configuration.
Dip
Switch #
Signal On Off Default
Position
1 PA7 Always leave this switch in the OFF position OFF
2 OSC OFF Always leave this switch in the ON position ON
3 SS3 3V 10k Pull down to GND OFF
4 SS2 3V 10k Pull down to GND OFF
5 SS1 3V 10k Pull down to GND OFF
6 SS0 3V 10k Pull down to GND OFF
7 H-P-ON Turn the modem off Turn the modem on OFF
8 RESET Keep modem reset Keep modem in working status OFF
On/Off
Switch
DC Jack
Input Supply
Port 2 / SPY PC Interface
DB9 Connector
8-way
DIP switch
On-board
LED indicators
SMA
Antenna
socket
SMA
Modem
socket
Host PC Interface
DB9 Connector
SPY Modem Interface
DB9 Connector
Audio Out
BNC Connector
Audio In
BNC Connector
3.15A Fuse
5X20mm
Lower 30-pin FPC Connector
For connection to modem
ADJ VCC
VCC
test pin
Ground
test pin
Boomer II
3 RDW
Header
connector
52-pin header connector
Parallel 30-pin FPC Connector
For signal access