User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Desense __________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 80 BM210012WT27
characterize and correct. Most host computers are very fast and include
numerous high frequency radiators. These can interfere with the radio
reception of the wireless modem.
The theoretical levels at which the receiver might be impacted are
derived from system coverage requirements and the sensitivity of the
radio. These goals are not set arbitrarily to improve product
performance, but to maintain the RF performance the networks demand
and the radios are designed to deliver.
Since each product is unique. The level of noise is very difficult to
predict, as is the amount of effort needed to control it. Measuring the
product in an early engineering phase is key to managing the situation.