User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Introduction ________________________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 10 BM210012WT37
Compliance Statement
The Wavenet Boomer-II OEM Modem Module has been tested and
found to comply with the limits for a class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation.
This modular transmitter is only approved for OEM integration into
final products that satisfy MPE categorical Exclusion Requirements of
2.1091 of the FCC rules. Accordingly the final product and its antenna
must operate with:
A. A minimum separation distance of 20 cm or more from all
persons using an antenna with gain not exceeding 3dBd
(or 5 dBi) in fixed or mobile applications or,
B. A minimum separation distance of 25 cm or more from all
persons using an antenna with gain not exceeding 6 dBd in
fixed applications only or,
C. A minimum separation distance of 35 cm or more from all
persons using an antenna with gain not exceeding 9 dBd in
fixed applications only or,
D. A minimum separation distance of 50 cm or more from all
persons using an antenna with gain not exceeding 12 dBd in
fixed applications only.
Note: The use of an antenna with gain greater than 5dBi for Mobile
applications will require an MPE measurement to satisfy the RF
Exposure requirements of 2.1091 of the FCC rules and notification of
the separation distance to all users and applicable documentation.
Separate approval is required for this module to operate in portable
products with respect to 2.1093 of FCC rules.
Wavenet has obtained certificates of Technical Acceptability for use in
Canada in accordance with the Radio Standards Procedure RSP-100
and Radio Standards Specification RSS119, Issue 3.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the manufacturer’s
instructions, may cause interference harmful to radio communications.
There is no guarantee however, that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.