User's Manual

Appendix B – SDK NCL-API and Port Server______________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 106 BM210012WT37
Status Request (non vendor
specific)
Response Structure Description
DTE for received SDUs.
NCL_R_RX_STATUS NCLStatus.rx_status Get receiver enable status
NCL_R_TX_STATUS NCLStatus.tx_status Get transmitter enable status
NCL_R_ANTENNA NCLStatus.antenna Get antenna selection status
NCL_R_RADIO_IN_RANGE NCLStatus.radio_in_range Get radio in range status
NCL_R_OB_MSG_COUNT NCLStatus.ob_msg_count Get count of outbound
messages queued
NCL_R_IB_MSG_COUNT NCLStatus.ib_msg_count Get count of inbound
NCL_R_FLOW_CONTROL NCLStatus.flow_control Get flow control status
NCL_R_EVENT_STATES NCLStatus.event_states Get current event reporting
(enable/disable) state
NCL_R_RADIO_CHANNEL NCLStatus.radio_channel Get current radio channel
NCL_R_CHAN_TABLE NCLChannelTable Read radio channel table
NCL_R_CHAN_BLOCK NCLChanBlock Read the channel block
NCL_R_BAT_LEVEL NCLStatus.bat_level Read the battery level
NCL_R_RPM_GID NCLGroupLlis Get RPM group IDs
NCL_R_VENDOR_ID NCLStatus.vendor_id Get vendor identification
NCL_R_DCHAN_TABLE NCLChannelTable Read the D-channel table
NCL_R_RF_STATISTICS Specific to RF protocol used:
RD-LAP [F] or MDC [G]
Read the RF statistics
Status Request (Wavenet
Technology specific)
Response Structure Description
WN_GET_STATUS_RADIO NCLWaveRadio Get RPM Radio Status
WN_GET_STATUS_BATTERY NCLWaveGen Get RPM Battery Status
WN_GET_STATUS_ONTIME NCLWaveGen Get RPM on-time status
WN_GET_STATUS_CONFIG NCLWaveGen Get RPM configuration status
Prototype:
int nclGetStatus (word *usSduTag, byte ucVendor, byte ucType, byte
ucRequest);
Description:
Command the RPM to send the requested status information.
Input:
 usSduTag Pointer to a word where the SDU tag can be stored
 ucVendor Vendor identifier. Use:
NCL_NO_VEND = 0 if not vendor specific or
NCL
_
VEND
_
WAVENET = ’F’ for Wavenet Technolo
gy
s
p
ecific