User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Boomer II User Manual & Integrator’s Guide _________________________________________________Installation
BM210012WT37 27 Copyright Wavenet Technology © November 2003
Installing the Modem
This section will help you to successfully integrate the Boomer II OEM
Modem into your custom application.
When integrating a wireless modem, internal connections and
placements are critical to a successful implementation. Specific
attention must be paid to the following support mechanisms:
Mechanical mounting
Serial interface and control
Antenna
DC power
Software
Desense control (see page 132 for further information)
The OEM wireless modem is well suited for mobile or fixed
applications. Ruggedised and capable of operating in extreme
environments, the modem can provide communications for a wide
variety of products.
Handheld Portable Terminal Use
Without question, handheld designs produce the most hostile
environment for an integrated modem. A handheld device, such as a
portable terminal, is typically battery powered, subjected to
temperature extremes, and designed to be physically robust.
When designing portable devices, you must consider the following
issues:
DC power noise levels on the host/terminal interface
Minimum operating voltage levels
Shutdown procedures
Device internal ambient temperature
Antenna gain and proximity to user
Repair and reprogramming facilities (pass-through mode of
operation)
Mechanical design for drop, vibration, dust, salt, and liquid spill
Note: Regarding the mechanical design, the Boomer II OEM modem is
designed assuming that the host/terminal controls these conditions.
Fixed Mount Usage
Fixed-mount usage eliminates most of the mechanical constraints of
handheld designs, although the requirements still apply. Fixed-mount
units are sometimes AC-line powered and require filtering to eliminate
the 50Hz or 60Hz noise that can impair modem operation, depending
upon country of use.