User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 30 BM210012WT37
The modem utilises connector part number 803-30-T-U from A-Point,
however, connector equivalents such as F006-52893 from Molex as
shown below, may also be used in the host/terminal.
Molex FPC Connector F006-52893
Pin 1 of the connector is adjacent to the LED window and its location
is shown below.
Data Interface Connector and Pin Numbering
The pin assignment of the Data Interface Connectors is shown in the
following table.
Pin 1
20.4mm
14.5mm
14.5mm