User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Boomer II User Manual & Integrator’s Guide _________________________________________________Installation
BM210012WT37 31 Copyright Wavenet Technology © November 2003
Data Interface Pin Descriptions
Pin Signal Description Signal Reset State
1 DCD Data Carrier Detect Output High Impedance
2 RXD Receive Data Output High Impedance
3 TXD Transmit Data Input 100k pull up to 3.3V
4 DTR Data Terminal ready Input 100k pull up to 3.3V
5 GND Ground Ground 0V
6 DSR Data Set Ready Output High Impedance
7 RTS Request to Send Input 100k pull up to 3.3V
8 CTS Clear to Send Output High Impedance
9 RI Ring Indicator Output High Impedance
10 HCRESET Modem Reset Input 40-80k pull up to 3.3V
11 TEST PIN Do not connect
12 HOSTPWR_ON Modem Power on/off Input High Impedance
13 LED0_MSGWTG Message Waiting Output High Impedance
14 LED1_INRANGE In Range Output High Impedance
15 LED2_LOWBAT Low Battery Output High Impedance
16 SS0/RXD2 Status Signal 0
Bi-directional
100k pull up to 3.3V
17 SS1/TXD2 Status Signal 1
Bi-directional
100k pull up to 3.3V
18 SS2 Status Signal 2
Bi-directional
100k pull up to 3.3V
19 SS3 Status Signal 3
Bi-directional
100k pull up to 3.3V
20 HOST 3.8V Supply Voltage Supply 3.4 – 4.2V
21 HOST 3.8V Supply Voltage Supply 3.4 – 4.2V
22 HOST 3.8V Supply Voltage Supply 3.4 – 4.2V
23 HOST 3.8V Supply Voltage Supply 3.4 – 4.2V
24 TEST-PIN Do not connect
25 HOST GND Ground Ground 0V
26 HOST GND Ground Ground 0V
27 HOST GND Ground Ground 0V
28 HOST GND Ground Ground 0V
29 TEST-PIN Do not connect
30 TEST-PIN Do not connect
Warning: Do not connect the TEST-PIN terminals (pin 11, 24, 29 and
30) or the modem may malfunction.
Note: The voltage range of most of the modem input pins is typically
0-3.3V, however, 0-5V can be used for compatibility with conventional
logic, unless otherwise stated.
A description of the above pins follows.