User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 34 BM210012WT37
Serial Communications Equivalent Circuit
Serial Communications Electrical Characteristics
Parameter Range Low High
Input Voltage 0-3.3 V OR 0-5V 0.8 V (max) 2.5 V (min)
Output Voltage 0 – 3.3 V 0.5 V (max) 2.3 V (min)
Input Current 100 µA (max) 100 µA (max)
Output Current 3.2 mA (max) 1.6 mA (min)
Note: DCD and INRANGE outputs share the same output line from the
micro-processor , and therefore the combined current consumption of
that line must not exceed 2mA.
Serial Communications Interface Definitions
J1
Pin #
Signal Description Signal Active State
1 DCD Data Carrier Detect Output Low when modem in-range
2 RXD Receive Data Output Low when active
3 TXD Transmit Data Input Low when active
4 DTR Data Terminal Ready Input Low when ready
6 DSR Data set ready Output Low when ready
7 RTS Request to send
Input High when host/terminal
requires data throttling
8 CTS Clear to send Output High when modem requires
d t th ttli