User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 36 BM210012WT37
Status Input/Output Interface Definitions
J1
Pin #
Signal Description Signal Active State
16 SS0 Status Signal 0 Input/ Output User configurable (future option)
17 SS1 Status Signal 1 Input/ Output User configurable (future option)
18 SS2 Status Signal 2 Input/ Output User configurable (future option)
19 SS3 Status Signal 3 Input/ Output User configurable (future option)
LED Indicators
The modem provides three on-board indicators (LEDs), for diagnostic
monitoring purposes as well as three modem controllable LED outputs
through the Data Interface Connector.
On-Board LED Indicators
The on-board LED’s are visible through a small window in the case of
the modem and are defined as below.
On-Board LED Indicator Definitions
Operating Mode
LED Indicator Colour
Off On Flashing
POWER Green Power off
Power normal and
locked on channel
Power normal and
scanning channels
TRANSMIT DATA Red No activity N/a Data Transmitted
RECEIVE DATA Green No activity N/a Data Received
Note: The LED’s may be disabled to minimise power consumption.
Refer to Appendix A - NCL Interface. All LED’s will flash on start-up
and the Receive and Transmit LED’s will flash on power down
regardless of the state of the LED disable control.
Position of On-Board LED Indicators
Power
Receive
Transmit