User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 40 BM210012WT37
Compliance Statement on page Error!
Bookmark not defined.
Impedance: 50Ω
Centre Frequency: 833MHz ± 5MHz (for 800MHz modem)
921MHz ± 3MHz (for 900MHz modem)
Frequencies of operation: 806 to 825MHz (for 800MHz transmit)
851 to 870MHz (for 800MHz receive)
896 to 902MHz (for 900MHz transmit)
935 to 941MHz (for 900MHz receive)
Acceptable return loss: VSWR < 1.5 or RL < -14dB (recommended)
VSWR < 2.0 or RL < -10dB (minimum)
The power output of the Boomer II OEM Modem is nominally 1.8W at
the antenna port. The antenna gain or loss will affect this value.
For reference Wavenet used the following ¼ wave whip antennae for
FCC certification and these are included in the Integrator Developer
Kits;
800 MHz modem: Radiall/Larsen - SPWH20832 (blue tip)
900 MHz modem: Radiall/Larsen - SPWH20918 (red tip)