User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Boomer II User Manual & Integrator’s Guide ____________________________________________ Modem Test Jig
BM210012WT37 55 Copyright Wavenet Technology © November 2003
Using the Modem Test Jig
The Boomer II Test Jig provides RS-232 serial interface ports between
a PC and the modem. It is designed to enable you to quickly interface
the Boomer II to a standard PC (through a COM port) or a terminal
device with an RS-232 serial port.
The test jig acts as a temporary host/terminal for the modem and
provides access points to the radio’s communication port, allowing you
to monitor activity with a logic probe, multimeter or oscilloscope.
Features
All Input/Output Lines configurable by jumpers and/or
accessible through parallel FPC connector.
On-board dual RS232 Serial Communication interface ports
with DB9 connectors
Through the SPY MODEM connector, you can monitor the data
transmitted from the modem (RX, DSR, and CTS).
Through the PORT 2/SPY PC connector, you can monitor the
data transmitted from the PC (TX, RTS and DTR), or talk to the
second serial port of the modem. You can make this choice by
putting all five jumper links on the right or left side of the RDW
header connector near the port.
Switches and LED indicators on SS0 - SS3 modem I/O lines.
On-board voltage regulator for Boomer II OEM supply rail.
On-board LEDs for three external signals:
Low battery
Message waiting
In range
On-board antenna matching network allowing conversion from
MMCX to SMA connectors.
Test Jig Updates
From time to time updates may be provided for the Boomer-II test jig
and these should be implemented as per the Update Notice. If you are
unsure if your test jig incorporates all the latest updates please contact
Wavenet Technology.