User's Manual

Table Of Contents

Modem Test Jig ____________________________________________ Boomer II User Manual & Integrator’s Guide

c. Press down the lock lever.

Note: If the cable has been partially inserted, or out of

alignment, the lock lever will not engage. Should this

occur, remove the cable (see below) and repeat steps

a-c.

Use the following procedure to remove the cable from the FPC

connector.

a. Lift up the lock lever of the FPC connector by flipping it

up with the nail of your thumb or index finger.

b. Remove the cable after the lock is released.

2. Install an antenna to the modem. Use either the on-board SMA

connection and an adapter cable between the modem MMCX

connector and the test jig SMA connector, or connect directly to

the modem itself.

3. Connect the PC serial cable to the DB9 connector marked

“PC”.

4. After making sure the power supply is set with the operating

voltage range of the modem switch the power supply on.

5. Select the DIP switch labelled H-P-ON to the ON position. The

green Power LED on the modem should illuminate.

You are now ready to communicate with the modem using the

PC as a host/terminal. The modem should be able to talk to the

PC by using Wavenet Commander software, or other NCL

protocol software. If the modem is in Hayes compatible mode,

then a terminal program will suffice.

Lock Lever