User's Manual

Appendix A - NCL INTERFACE ________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 82 BM210012WT37
channel.
RX_REG_DENIED ASCII 7 Flash LED for
registration denial.
HW_EVENT ASCII E HW_EVENT_BIT $01 Hardware event.
HW_SELF_TEST ASCII 1 Self-test failed.
HW_LOW_BATT ASCII 2 Low battery.
HW_MEM_FULL ASCII 3 Memory full.
HW_BATT_OK ASCII 4 Battery level OK.
HW_MEM_OK ASCII 5 Memory OK.
HW_OFF ASCII 6 Device shutdown
imminent.
HW_BATT_WARN ASCII 7 Battery at warning
level.
RCV_ERR ASCII F Unreceivable message
event.
RCV_TX_DISABLED ASCII 1 ACK required, PDU
received. Cannot
ACK, transmitter
disabled. PDU
discarded.
CONTROL ASCII G CONTROL_BIT $20 Control event.
CONNECT ASCII 1 NCL connect between
RPM and DTE .
ASCII
H..Y, 1..9
Reserved.
VENDOR ASCII Z Vendor-specific event.
 Response Status SDUs (RESP, ASCII C)
Responses Value Parameters Value Description/Error Code
SUCCESS ASCII 1 Successful.
IBQ_FLUSHED ASCII a Error code. Pending SDUs in inbound queue flushed;
transmitter disabled. Used only if the RPM cannot support
message buffering while transmitter disabled.
XFAIL ASCII 2 Command execution error. Note the following error codes:
NO_RESPONSE ASCII A No response from network.
NO_ACK ASCII B Negative ACK received.
HOST_DOWN ASCII C Host access is down.
NOT_REGISTERED ASCII D RPM not registered.
LOW_BATTERY ASCII E Low battery—cannot transmit.
IBQ_FULL ASCII F RPM inbound queue is full.
TX_DISABLED ASCII G Radio transmitter is disabled.
BUSY ASCII H Resource is unavailable.
NOT_AVAILABLE ASCII I Unimplemented services.
HW_ERROR ASCII J Generic error.
INVALID_MODE ASCII K Invalid mode of operation.
NO_MESSAGES ASCII L No outbound messages available.
MSGS_PENDING ASCII M Cannot execute command due to pending inbound messages.
SW_ERROR ASCII N Software error.
OUT_OF_RANGE ASCII O RF not in range.
PACKET_ERROR ASCII Z SDU data corruption. True only if confirmed delivery mode
enabled.