User's Manual

Appendix A - NCL INTERFACE ________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 88 BM210012WT37
indicates disabled, a one indicates
enabled.
NCL Event Flags: Byte which indicates the start-up state of
the NCL event reporting. A set bit
indicates the relevant event is enabled. A
cleared bit indicates the event is disabled.
The bits are as follow:
Bit 7 - Reserved (ignore)
Bit 6 - Rx_Error
Bit 5 - Control
Bit 4 - Rcv_Msg_Data
Bit 3 - Rcv_Msg_Notify
Bit 2 - Tx
Bit 1 - Rx
Bit 0 - Hwr
Number of Group LLIs: Number of Group LLI fields which
follow.
Group LLIs: Each is a four byte unsigned integer. The
number of Group LLIs is given in the
previous field.
Number of Static Channels: Number of channel fields
which follow.
Static Channels: Each is a two byte unsigned integer. The
number of Static Channels is given in the
previous field.
WN_GET_SERIAL: Get modem serial number (NCL string “ZFts”).
SUCCESS is followed by a block of status information in the format
shown below:
WN_GET_SERIAL Response Format:
7 6 5 4 3 2 1 0
Modem serial number [10 bytes]
The modem serial number is unique to each modem and consists of
ASCII characters. The tenth character is typically a null termination
character.
 Generic set RPM Configuration command type 1
(WN_SET_PARAM):
This command allows the DTE to set the configuration settings of
certain aspects of the modem.