User's Manual

Table Of Contents
Appendix A - NCL INTERFACE ________________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © November 2003 92 BM210012WT37
Generic get RPM Configuration command
(WN_GET_PARAM):
This command allows the DTE to get the configuration settings of
certain aspects of the modem. This section should be seen together
with the previous section (“Generic GET RPM Configuration
command”).
FORMAT:
WN_GET_PARAM Command Syntax (NCL string “ZF$…”):
WN_GET_PARAM Response Syntax:
OPERAND DESCRIPTIONS AND RESPONSES:
The various Vendor Parameter values that can be requested are listed
in the previous section (“Generic set RPM Configuration command”).
The responses to these commands obey the WN_GET_PARM response
syntax as shown above. The one exception is the “Get Active Profile”
command, which returns more than just the “active profile”:
Parameter Number A 16-bit field, which is unique to each
parameter, used to differentiate them.
Parameter Length A 16 bit field, which indicates the length
of the following parameter, in bytes.
Parameter Value The actual value of the parameter. The
format is parameter specific.
WN_ PROFILE Get list of profiles from modem (NCL string
“ZF$f\00” with “\00” representing one byte with value of zero).
SUCCESS is followed by a block of information in the format shown
below:
CMND Length SDU Tag
VENDOR
‘Z’
‘F’ ‘$’
WN_GET_PARAM
VEND_WAVENET
Parameter number
CMND Length SDU Tag
VENDOR
‘Z’
‘F’ ‘$’
SUCESS
VEND_WAVENET
Parameter
Length
Parameter
Value