User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer˚III OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A – Guide to Desense
- Appendix B - Numeric Conversion Chart
- Appendix C – Boomer-III Specifications
- Appendix I - Glossary
Installation________________________________________________ Boomer-III User Manual & Integrator’s Guide
Copyright Wavenet Technology © October 2003 24 BM310012WT05
the 50Hz or 60Hz noise that can impair modem operation, depending
upon country of use.
Other considerations include mobile usage, which typically implies
vehicular applications. Some of the design implications of mobile
usage include:
Resets
The design must attempt to eliminate modem resets caused by supply
voltage drops while the vehicle is starting. This is very disruptive to the
network link.
Supply and Noise Levels
Special care is required to ensure the modem is not subjected to DC
voltages exceeding specifications. This could create costly damage to
the RF section of the modem. Adhere to the power supply noise
specifications in your design.
Antenna
The antenna must be mounted like any other cellular or land mobile
radio antenna. Usually the vehicle roof provides a good ground plane
unless it is fabricated of non-metallic material such as fibreglass.
Mounting the Boomer-III OEM Modem to Your Device
Before using your modem you must:
Mount the Boomer-III OEM Modem to your device
Connect the Data Interface Port
Connect and position the antenna
Supply power
A picture of the Boomer-III OEM Modem is shown below.
LED
Indicators
Data Interface Port
RF Connector
Pin 1