User manual

® Waves System V 2.0 - 2013

I.D. AL - NanoPlayer mkII - MP3 & Wav audio player - User manual

5 - Infrared: The NanoPlayer mkII can be controlled with a infrared remote handset (not supplied with the

OEM board - available separately).

ID-AL remote control handset

6 - Input on dry contact: Connect a push button, presence detector, smoke, heat, light or pressure

sensor ... relay output, or any type of contact to trigger the player when happening of an event. Create

a brief contact between «SW» input and the ground G.

- 12V (+) power supply output

(to power an external device)

- Input contact (SW)

- Ground (G)

7 - SD or SDHC memory card: Insert a memory card in the slot (minimum storage capacity 64Mo).

When inserting or removing the memory card, make sure that the player is powered off.

8 - Volume setting: volume setting is provided by 2 push buttons. Adjust volume by pressing Volume

+ and Volume - buttons. The volume setting is stored on the SD/SDHC card.

9 - 10 - 11 - Extension connector: This 10 pins connector offer few functions. External volume setting,

external contact, power supply input/output and an optionnal serial link (not provided in standard firmware)

- 8 -

+12v (power supply in or out)

Vol+

Vol-

Volume setting

External input contact

+12v (power supply in or out)

Optionnal serial link (not activated)

Ground / 0V (power supply)

Ground / 0V