SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 4: Patch Window
SoundGrid Studio/ User Guide
69
Mixer Outputs
A mixer channel or buss can be patched to any available I/O that has been assigned to SoundGrid Studio.
The Output view has two grid filters: Channel Direct outs and Mix Busses out. Mixer outputs are displayed on the left,
assigned I/O device channels are displayed along the top.
Each channel or buss can output from one of four sources, indicated by the multi-colored buttons. To select the source,
click on its button:
On a stereo buss, source settings apply to both left and right channels. An I/O device can receive only one source signal.
INP
Green
Before all processing, after input gain
PRE
Purple
Pre-fader, after processing
PST
Orange
Post-fader, after processing
PSP
Turquoise
Post-fader, after processing, after panner