SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
91
Channel Strip Sections Common to All Layer Modes
The bottom section of all channel strips is the same in all modes.
PAN/BALANCE/ROTATION KNOB
Pans a mono signal between left and right when sent to a stereo buss. The stereo panner/rotator controls the
balance of a stereo signal or moves the image without changing its internal balance.
CHANNEL MUTE
A user-selected Mute for a specific channel will be solid red. A Mute activated by a DCA fader or asolo will flash
red.
• When a mute button on a channel is flashing, click it again un-mute it.
CHANNEL SOLO
Activates a send to the Solo buss for channel monitoring. Clear all instances with the Clear Solo button on the
Top Bar.
FADER
When the fader is touched, its position value is displayed above the fader. Set pre-fader or post-fader metering
in the Setup window.
When under the control of a link fader, the channel fader stays in its original position, while the DCA offset value
is shown as a “ghost fader.”
ALT+Click to return a fader to its default position. Range: -144 dB to +10 dB
METER
Stereo or mono peak meter. Clip is indicated with red LED at the top of the meter. Set input or output meter
display in the Settings window.
Range: -INFINITY to +10 dB
PEAK LEVEL INDICATOR
Peak hold time, clip hold time, and clip indicator threshold are set in the Setup window.