SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
96
Route Mode
The Route mode patches Input, Group, AUX, and Monitor layers channels. Patching is different for each layer.
ROUTE MODE: CHANNELS LAYER
Input I/O Channel: Open the drop-down menu to select an input device channel. Use this menu, too, to flip the
channel between mono and stereo.
Input: Choose between two sets of I/O device inputs—A or B. This provides alternate inputs to each channel
without changing mixer and plugin settings.
Group Assignments: Assigns channel to up to eight mix groups. Groups are controlled in the GRP/AUX layer.
Main Outputs Assignments: Assigns channel to the main mix.
Channel Direct Outputs: Assigns channel to direct or mix outputs. Devices assigned to the mixer are
available for patching from this menu. Grayed-out I/O channels are unavailable.