Instruction manual

7
Fig.15
Fig.17
Fig.16
INSERTING THE EYEPIECE (Fig.17)
1) Loosen the thumbscrew on the end of the focus tube.
2) Insert the diagonal into the focus tube and re-tighten
the thumbscrew to hold the diagonal in place.
3) Loosen the thumbscrews on the diagonal.
4) Insert the desired eyepiece into diagonal and secure
by re-tightening the thumbscrews.
INSERTING THE EYEPIECE (Fig.15, 16)
1) Unscrew the thumbscrews on the end of the focus
tube to remove the black plastic end-cap.
2) Insert the desired eyepiece and secure it by
retightening the thumbscrews.
POWERING THE
EQ6 MOTORS (Fig.18)
1) Insert eight "D" cell batteries
into the battery case.
2) Plug the DC power cord
from battery case into the
DC 12V outlet on the side
of the mount.
CONNECTING THE
HAND CONTROL (Fig.19)
1) The EQ6 hand control has a phone
type connector. Plug the phone jack
connector into the outlet on the
mount. Push the connector into
the outlet until it clicks into place.
Fig.18
Fig.19
EYEPIECE ASSEMBLY (for reflectors)
EYEPIECE ASSEMBLY (for refractors)
HAND CONTROL INSTALLATION (for HEQ5)
POWERING THE
EQ6 MOTORS (Fig.20)
1) Insert eight "D" cell
batteries into the
battery case.
2) Plug the DC power
cord from battery
case into the DC
12V outlet on the
side of the mount.
CONNECTING THE
HAND CONTROL (Fig.21)
1) The EQ6 hand control has
a phone type connector.
Plug the phone jack connector
into the outlet on the mount.
Push the connector into the
outlet until it clicks into place.
Fig.20
Fig.21
Po
we
r
DC
1
2
V
HAND CONTROL INSTALLATION (for EQ6)