Specifications

Chapter 27: AIR Reverb 151
Reverb Plug-In Reverb Section
The Reverb section provides control over the
stereo width of the reverb algorithm.
In Width
Widens or narrows the stereo width of the in-
coming audio signal before it enters the reverb
algorithm.
Out Width
Widens or narrows the stereo width of the signal
once reverb has been applied.
Delay
Sets the size of the delay lines used to build the
reverb effect. Higher values create longer rever-
beration.
Reverb Room Section Controls
The Room section offers control over the overall
spatial feel of the simulated room.
Ambience
This control affects the attack of the reverb sig-
nal. At low settings, the reverb arrives quickly,
simulating a small room. At higher settings, the
reverb ramps up more slowly, emulating a larger
room.
Density
Adjust the Density control to change the rate at
which the sound density of the reverb tail in-
creases over time. Higher Density settings cre-
ate a smoother reverberated sound. Lower set-
tings result in more fluttery echo.
Reverb High Frequencies
Section Controls
The High Frequencies section provides controls
that let you shape the tonal spectrum of the re-
verb by adjusting the decay times of higher fre-
quencies.
Time
Adjust the Time control to decrease or increase
the decay time for mid- to high-range frequency
bands. Higher settings provide longer decay
times and lower settings provide shorter decay
time. With lower settings, high frequencies de-
cay more quickly than low frequencies, simulat-
ing the effect of air absorption in a hall.
Freq
Adjust the Frequency control to set the fre-
quency boundary between the mid- and high-
range frequency bands.
Cut
The High Cut control lets you adjust the fre-
quency for the High Cut filter (1.00–20.0 kHz).
Adjusting the High Cut control to change the de-
cay characteristics of the high frequency compo-
nents of the Reverb. To cut the high-end of the
processed signal, lower the frequency.