Specifications

Audio Plug-Ins Guide256
Depth
The Depth control lets you adjust the amount of
modulation applied to the Delay time.
Feedback
The Feedback control lets you adjust the amount
of delay feedback for the Flanger. At 0%, the de-
lay repeats only once. At +/–100%, the Flanger
feeds back on itself.
Mix
The Mix control lets you balance the amount of
dry signal with the amount of wet (flanged) sig-
nal. At 50%, there are equal amounts of dry and
wet signal. At 0%, the output is all dry and at
100% it is all wet.
The Mix control can be used to create an “infi-
nite phaser” effect between the dry and shifted
signals, which is always rising or always falling
(depending on the direction of shift)
Pre-Delay
The Pre-Delay control sets the minimum delay
time in milliseconds.
AIR Flanger LFO Section
Controls
The LFO section provides controls for the Low
Frequency Oscillator (LFO) used to modulate
the Delay time.
Wave
The Wave control lets you interpolate between a
triangle wave and a sine wave for the modulat-
ing LFO.
L/R Offset
The L/R Offset control lets you adjust the phase
offset for the LFO waveform applied to the left
and right channels.
Retrigger
Click the Retrigger button to reset the LFO
phase. This lets you manually start the filter
sweep from that specific point in time (or using
automation, at a specific point in your arrange-
ment). Clicking the Trig button also forces the
Mix control up if it is too low while the button is
held; this ensures that the sweep is audible.
AIR Flanger EQ Section Controls
The EQ section provides controls for cutting
lows from the Flanger signal, and inverting
phase.
Low Cut
The Low Cut control lets you adjust the Low Cut
frequency for the Flanger, to limit the Flanger
effects to higher frequencies.
Phase Invert
When Phase Invert is enabled, the wet signal’s
polarity is flipped, which changes the harmonic
structure of the effect.