Datasheet

7. Electrical Characteristics
7-1) Absolute maximum rating
Parameter Symbol Rating Unit
Logic Supply Voltage V
CI
-0.3 to +6.0 V
Logic Input Voltage V
IN
-0.3 to VCI +2.4 V
Operating Temp. range T
OPR
0 to +50 ℃
Storage Temp. range T
STG
-25 to +70 ℃
7-2) Panel DC Characteristics
The following specifications apply for: VSS = 0V, VCI = 3.3V, TA = 25℃
Parameter Symbol Conditions Min Typ Max Unit
Single ground V
SS
- - 0 - V
Logic Supply Voltage VCI - 2.3 3.3 3.6 V
High level input voltage VIH Digital input pins 0.7VCI - VCI V
Low level input voltage VIL Digital input pins 0 - 0.3VCI V
High level output voltage VOH Digital input pins , IOH= 400uA VCI-0.4 - - V
Low level output voltage VOL Digital input pins , IOL= -400uA 0 - 0.4 V
Image update current I
UPDATE
- - 8 10 mA
Standby panel current Istandby - - - 5 uA
Power panel（update） P
UPDATE
- - 26.4 40 mW
Standby power panel P
STBY
- - - 0.0165 mW
Operating temperature - - 0 - 50 ℃
Storage temperature - - -25 - 70 ℃
Image update Time at 25 ℃ - - - 6 8 Sec
Deep sleep mode current I
VCI
DC/DC off
No clock
No input load
Ram data not retain
- 2 5 uA
Sleep mode current I
VCI
DC/DC off
No clock
No input load
Ram data retain
- 35 50 uA
- The Typical power consumption is measured with following pattern transition: from horizontal 2 gray scale pattern to vertical
2 gray scale pattern.(Note 7-1)
- The standby power is the consumed power when the panel controller is in standby mode.
- The listed electrical/optical characteristics are only guaranteed under the controller & waveform provided by Waveshare.
- Vcom is recommended to be set in the range of assigned value ± 0.1V.
Note 7-1
4.2" e-Paper
www.waveshare.com
27／45