Datasheet

Compute Module IO Board Plus User Manual

Version：V1.0，Date：20171101

HOW TO USE

INSTALLATION

CM3

1. Pull the jumpers of USB SLAVE 1/2/3/4 SELECTION (you need to pull two jumpers

here), set the BOOT ENABLE USB SLAVE jumpers to EN position.

2. Install USB driver. Run the software rpiboot_set to install the drivers and boot tool.

3. Plug the USB SLAVE port of IO Board Plus into your host PC USB. (don’t need to

connect power adapter to the IO Board Plus )

4. Run the rpiboot.exe tool. After a few seconds, the CM3 eMMC will be recognized as a

disk.

5. Run WinDiskImager.exe tool to burn the image to eMMC of CM3.

Note:

Ensure you are not writing to any USB devices while installation.

Because the eMMC of CM3 is only 4G, the image file flashed should be small than 4G. If you

want the GUI, you can install it with these commands after installation

sudo apt-get update

sudo apt-get install raspberrypi-ui-mods

CM3L

1. Download the image for CM3L

2. Connect the SD card to computer with card reader. The capacity of SD card should

larger than 8G.

3. Run the Win32DiskImager.exe, choose the CM3L image and burn it to SD card.

4. After burning successfully, insert the card to the card slot of IO Board Plus

CONNECTING DISPLAY AND CAMERA

Download the test image provide by us and install them.