Datasheet

6
- The maximum power consumption is measured using 85Hz waveform with following pattern transition:
from pattern of repeated 1 consecutive black scan lines followed by 1 consecutive white scan line to that
of repeated 1 consecutive white scan lines followed by 1 consecutive black scan lines (Note 6-1).
- The Typical power consumption is measured using 85Hz waveform with following pattern transition: from
horizontal 4 grey scale pattern to vertical 4 grey scale patterns (Note 6-2).
- The standby power is the consumed power when the panel controller is in standby mode.
- The listed electrical/optical characteristics are only guaranteed under the controller & waveform provided
by manufactory
- V
COM
is recommended to be set in the range of assigned value ± 0.1V
- The maximum I
COM
inrush current is about 1.64 mA
Note6-1
The maximum power consumption
Note6-2
The typical power consumption
9.7inch e-Paper