CAN Board - Datasheet
Table Of Contents
- FEATURES
- APPLICATIONS
- DESCRIPTION
- Function Tables
- Terminal Functions
- equivalent input and output schematic diagrams
- absolute maximum ratings over operating free-air temperature (see Note \ 1) (unless otherwise noted) †
- recommended operating conditions
- ELECTRICAL SPECIFICATIONS
- driver electrical characteristics over recommended operating conditions \ (unless otherwise noted)
- driver switching characteristics over recommended operating conditions(\ unless otherwise noted)
- receiver electrical characteristics over recommended operating condition\ s (unless otherwise noted)
- receiver switching characteristics over recommended operating conditions\ (unless otherwise noted)
- device switching characteristics over recommended operating conditions (\ unless otherwise noted)
- device control-pin characteristics over recommended operating conditions\ (unless otherwise noted)
- PARAMETER MEASUREMENT INFORMATION
- TYPICAL CHARACTERISTICS
- APPLICATION INFORMATION
- MECHANICAL DATA
- IMPORTANT NOTICE
SN65HVD230
SN65HVD231
SN65HVD232
SLOS346G – MARCH 2001 – REVISED JUNE 2002
19
www.ti.com
APPLICATION INFORMATION
TMS320Lx2403/6/7
3.3-V
DSP
Implementation
ISO 11898 Specification
Application Specific Layer
Data-Link
Layer
Logic Link Control
Medium Access Control
Physical
Layer
Physical Signaling
Physical Medium Attachment
Medium Dependent Interface
Embedded
CAN
Controller
SN65HVD230
CAN Bus-Line
Figure 27. The Layered ISO 11898 Standard Architecture
The SN65HVD230 family of CAN transceivers are compatible with the ISO 11898 standard; this ensures
interoperability with other standard-compliant products.
application of the SN65HVD230
Figure 28 illustrates a typical application of the SN65HVD230 family. The output of a DSP’s CAN controller is
connected to the serial driver input, pin D, and receiver serial output, pin R, of the transceiver. The transceiver
is then attached to the differential bus lines at pins CANH and CANL. Typically, the bus is a twisted pair of wires
with a characteristic impedance of 120 Ω, in the standard half-duplex multipoint topology of Figure 29. Each end
of the bus is terminated with 120-Ω resistors in compliance with the standard to minimize signal reflections on
the bus.