User's Manual

ManualsBrandsWavesystec ManualsAudio EquipmentBluetooth Headset

■ Safety Precautions

Please read this guidebook carefully and follow the instruction.

1. To avoid any damage or malfunction of the unit do not drop unit from high places.

2. Keep away unit from humidity, water and any other liquid. And if the unit is exposed by water, moisture

and other liquid directly, then don’t operate it normally to avoid any electrical shock, explosion and damage

of the unit.

3. Do not place or keep the unit near the heat sources such as direct sun light, radiators, stoves or other

apparatus which produce heat. It may cause explosion, degrade of performance and reduce battery life.

4. Do not modify, repair & disassemble unit at discretion. (Especially battery: It may cause an explosion.)

5. Do not place the heavy objects on the unit.

6. Use only supplied and approved charger.

7. Use soft cloth or rag to clean. Avoid using chemical solutions such as benzene and thinner.

8. Too high volume for long hours may get your hearing weaker.

9. If you keep the volume high on the move, this may cause unfortunate accidents

10. If you use the player on/in a bicycle, an auto bike, or other vehicles, this may lead to unwanted accidents.

11. Replacement or service must be done at a qualified service center or returned to the manufacturer.

12. Unplug this unit when unused for long periods of time or during lightening storms.

Note: What is described in this manual may be subject to change without notice in advance due to functional

improvement and/or specification upgrade.

Cautions: ELECTRIC SHOCK HAZARD

The battery used in this device may present a risk of fire or chemical burn if mis-treated.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation. Note: The manufacturer is not responsible for ANY interference, for example

RADIO or TV interference, caused by unauthorized modifications to this equipment. Such modifications could void the

user’s authority to operate the equipment.

INFORMATION TO USER FCC P15.21

CAUTION: changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

This device is CE marked according to the provision of the R&TTE Directive (99/5/EC). Here by, Wavesystec Co., Ltd.,

declares that this product is in compliance with the essential requirements and other relevant provisions of Directive

1999/5/EC. For further information please visit www.b-on.co.kr

Summary of content (7 pages)

PAGE 1
■ Safety Precautions Please read this guidebook carefully and follow the instruction. 1. To avoid any damage or malfunction of the unit do not drop unit from high places. 2. Keep away unit from humidity, water and any other liquid. And if the unit is exposed by water, moisture and other liquid directly, then don’t operate it normally to avoid any electrical shock, explosion and damage of the unit. 3.
PAGE 2
Please note that this product uses radio frequency bands not harmonized within EU. Within the EU this product is intended to be used in Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, The Netherlands, Portugal, Spain, Sweden, United Kingdom and within EFTA in Iceland, Norway and Switzerland. Bluetooth is a trademark owned by the Bluetooth SIG, Inc.
PAGE 3
9. REW : Back to previous song 10. Charging Point : Contacts for charging the battery ■ To charge the battery 1. Connect BT-1000’s USB Port (A) to PC’s USB Port (B). 2. When charging, BT-1000 indicator light flashes Red. 3. When the Red indicator light is turned off, disconnect BT-1000’s USB Port from PC’s USB Port (B). * Recharging time It usually takes approximately 2 hours to fully recharge the BT-1000 battery. * Low Battery Warning The Red indicator light is turned on. Battery Notice 1.
PAGE 4
■ Operation * To pare the BT-1000 Before you use BT-1000 for the first time, you should pair BT-1000 with the device that you want to use it with, such as a mobile phone applied Bluetooth. The following section describes how to pair BT-1000 to a typical Bluetooth phone. Ensure your BT-1000 is within 30 feet (10 meters) of the Bluetooth phone from access range. 1. Set up BT-1000 as a state of ready for registration.
PAGE 5
③ Say the voice tag name. Notice: Not all Bluetooth phones support voice dialing, please refer to your phone’s manual to make sure whether your phone supports this feature. * To receive / answer a call ① When you receive an incoming call with the BT-1000 on and paired, the beep sound is heard and the GREEN indicator light will be blinked two times with five-second interval. ② Answer the call by pressing the ③ To end a call, Press the button briefly. button briefly.
PAGE 6
* To pause the music Press button briefly during playback. * REW/FF Press / button briefly during playback. To talk during playback This function is only available for connecting Bluetooth phone to Stereo Audio Out and Hands-free Profile. To make a call during playback Press button briefly to stop the music during playback. Press button for at least 3 seconds in a stat of ready. (The beep sound is heard two times.
PAGE 7
Standby Time : Maximum 200 hours Talk Time : Approx. 15 hours Music Playing Time : Approx. 6 hours Recharging Time : Approx.