User's Manual

■ Operation
* To pare the BT-1000
Before you use BT-1000 for the first time, you should pair BT-1000 with the device that you want to use it with, such as a
mobile phone applied Bluetooth. The following section describes how to pair BT-1000 to a typical Bluetooth phone.
Ensure your BT-1000 is within 30 feet (10 meters) of the Bluetooth phone from access range.
1. Set up BT-1000 as a state of ready for registration.
The Green Light and the Red Light is blinked
consecutively by pressing button for at least 3 seconds and
in a state of power-off.
2. Register BT-1000 referring to User’s Manual to pair
3. Enter BT-1000 PIN number “0000” on the phone.
4. When the registration is finished, then the beep sound is heard.
*Connecting the BT-1000 to the Bluetooth device
1. Turn the BT-1000 on.
2. Connect the BT-1000 to the Bluetooth device referring to User’s manual.
3. When the registration is finished, then the beep sound is heard.
* To power on & power off
Power On : Press and hold the ( button for at least 3 seconds. (The beep sound is heard and the GREEN
indicator light is turned on.)
Power Off : Press and hold the button for at least 3 seconds. (The beep sound is heard and the GREEN
indicator light is turned off after blinking for 2 seconds.)
* To make and receive a call with BT-1000
You can place a call with your BT-1000 in these two ways:
- [Dialing voice a number from the phone / last number dialing]
- [Using Voice Dialing]
In both cases, you must first link your BT-1000 and phone as described in “Paring the BT-1000” on page 3.
1) To dial voice a number from the phone / last number dialing
Press button briefly to stop playing music during playback.
Press button for at least 3 seconds in a state of ready.( The beep sound is heard two times.)
To end a call, press the button briefly. The users need to press button two times according to specific types
of Bluetooth devices.
2) To use Voice Dialing
① Press button to stop playing music during playback.
② Press button briefly for 2 seconds in a state of ready. (The beep sound is heard two times.)