Specifications

User Manual 301/302
OUTPut
Subsystem
This subsystem controls the characteristics of the output. It controls
filter type and filter cutoff frequency. It is also used to control the sync
output, source and position. Optional nodes were omitted from these
commands. Factory defaults after *RST are shown in bold typeface.
Parameter low and high limits are given where applicable.
Keyword Parameter Form Default,Low Limit,High Limit
:OUTPu OFF|ON|0|1 OFF
:FILTer OFF|ON|0|1 OFF
:FREQuency 150M|10M|5M|2.5M|800K
:MODE NORMal|AUXiliary NORMal
:SYNC OFF|ON|0|1 OFF
:SOURce BIT|LCOMplete|PULSe BIT
:POSition <position> 0,0,4M/16M
:WIDTh <width> 1,1,99
OUTPut OFF | ON | 0 | 1
Purpose
This command will turn the 302 output on and off.
• ON or 1 will set the output on
• OFF or 0 will set the output off
OUTPut?
Response
The 302 will return 1 if the output is on, or 0 if the output is off.
OUTPut:FILTer OFF | ON | 0 | 1
Purpose
This command will connect and disconnect filters to the 302 output.
• ON or 1 will connect filters
• OFF or 0 will disconnect filters
OUTPut:FILTer?
Response
The 302 will return 1 if filters are connected to the output, or 0 if filters are not connected to the output.
OUTPut:FILTer:FREQuency 150M | 10M | 5M | 2.5M | 800K
Purpose
This command will select which filter is connected to the 302 output.
• 150M will connect 150 MHz low pass elliptic filter
• 10M will connect 10 MHz low pass elliptic filter
SCPI Command Reference
95