Specifications

User Manual 301/302
Programming the
Output Amplitude
and Offset
Use the following command to program the peak-to-peak amplitude of
the generated waveform:
VOLTage {<amplitude>|MINimum|MAXimum}.
MIN selects the smallest possible amplitude. MAX selects the largest
possible amplitude. The default amplitude is 2.00 V (into 50Ω).
The query:
VOLTage?
Queries the output amplitude and returns a value in volts.
The command:
VOLTage:OFFSet <offset>
Sets the offset. The default offset is 0 V.
The query:
VOLTage:OFFSet?
Queries the output offset and returns a value in volts.
Using WaveWiz, this is performed in the Standard Tab of the
Instrument Control Panel. See Figure 3.10 Below
Figure3.10 Adjust standard signal amplitude and frequency
Configuring the Instrument
33