Installation guide

SmartSensor 105 User Guide – Wavetronix LLC 9/20/07 - -

Introduction

The Wavetronix SmartSensor utilizes patented Digital Wave Radar™ technology to

detect lane occupancy, traffic volume and average speed in up to eight lanes of traffic

simultaneously. Classified as Frequency Modulated Continuous Wave (FMCW) radar,

SmartSensor collects data using a 10.525 GHz (X-band) operating radio frequency.

The installation and configuration process is quick and easy. Once installed,

SmartSensor configures automatically, requires little or no on-site maintenance and may

be remotely reconfigured. This installation guide provides the step-by-step process for

installing and configuring SmartSensor, including mounting and alignment guidelines

and instructions for both automatic and manual sensor configurations. Any questions

about the information in this guide should be directed to Wavetronix or your distributor.

Unpacking the Sensor

A typical sensor package contains the following items:

 10.525 GHz SmartSensor Radar Traffic Sensor

 SmartSensor Mounting Kit

 Installation Guide

 SmartSensor Manager Software

Check the packing slip for actual contents. If any of these items are missing,

note the serial number located on the back of the sensor and contact your

distributor.

Additional products may be purchased through your distributor. The following optional

items are not included unless specifically ordered (check packing list for actual

inventory):

 SmartSensor Cable with Connector

 Click! 172/174 contact closure adapter

 Click! 200 surge protector

 Click! 201 1 Amp AC-to-DC converter

 Click! 202 2 Amp AC-to-DC converter

 Click! 300 RS-232-to-RS-485 adapter

 Click! 301 Ethernet to serial adapter

 Click! 400 900 MHz Spread Spectrum Radio

 Click! 401 Serial-to-802.11b Converter Module