User's Manual
15
CHAPTER 1 o INSTALLING THE SMARTSENSOR 105
34 / 10.4 23 / 7 19 / 5.8 34 / 10.4
35 / 10.7 23 / 7 20 / 6.1 35 / 10.7
36 / 11 23 / 7 20 / 6.1 36 / 11
37 / 11.3 23 / 7 20 / 6.1 37 / 11.3
38 / 11.6 24 / 7.3 21 / 6.4 38 / 11.6
39 / 11.9 24 / 7.3 21 / 6.4 39 / 11.9
40 / 12.2 25 / 7.6 22 / 6.7 40 / 12.2
41 / 12.5 25 / 7.6 22 / 6.7 41 / 12.5
42 / 12.8 26 / 7.9 22 / 6.7 42 / 12.8
43 / 13.1 26 / 7.9 22 / 6.7 43 / 13.1
44 / 13.4 27 / 8.2 23 / 7 44 / 13.4
45 / 13.7 27 / 8.2 23 / 7 45 / 13.7
46 / 14 28 / 8.5 23 / 7 46 / 14
47 / 14.3 28 / 8.5 24 / 7.3 47 / 14.3
48 / 14.6 29 / 8.8 24 / 7.3 48 / 14.6
49 / 14.9 29 / 8.8 24 / 7.3 49 / 14.9
50–180 / 15.2–54.9 30 / 9.1 25 / 7.6 Must be < offset
Mounting Height GuidelinesTable 1.1 –
Attaching the Mount Bracket to the Pole
Before aaching the mount bracket to the pole, rst make sure that your cables
are long enough to reach the sensor height and to stretch across the distance
from the sensor to the cabinet.
Follow the steps below to correctly aach the mount to the pole (see Figure 1.2):
Look up the recommended mounting height from Table 1.1.1
Insert the stainless steel straps through the slots in the mount bracket. 2
Position the mount on the pole so that the head of the mount is pointing 3
towards the middle of the lanes of interest.
Tighten the strap screws.4