User's Manual

CHAPTER 1 o INSTALLING THE SMARTSENSOR 105

Attaching the Mount Bracket to the PoleFigure 1.2 –

Note

Depending on the site and type of trac, the sensor may tend to over-

or undercount. If the sensor is overcounting, reduce the height of the

sensor by three ft. (0.9 m) and recongure the sensor. If the sensor is

undercounting, increase the height of the sensor by three ft. (0.9 m)

and recongure. Normally, reducing the height of the sensor improves

performance.

Attaching the Sensor to the Mount Bracket

Use the following steps to securely fasten the sensor to the mount bracket (see

Figure 1.3).

Align the bolts on the back of the SmartSensor with the holes in the 1

mounting bracket. The large 25-pin connector on the SmartSensor should

be pointing towards the ground.

Place the lock washers onto the bolts after the bolts are in the mounting 2

bracket holes.

Thread on the nuts and tighten.3