User's Manual

In this Chapter
Lane Conguration – Automatic 
Lane Conguration – Manual 
Verifying Lane Conguration 
Seing up lanes is simple in SmartSensor Manager because the software will
do it for you with the click of a buon. Additionally, if SmartSensor Manager is
unable to correctly congure due to barriers, obstacles or irregular lanes, you
can use the Manual Conguration mode to adjust.
Note
Free-owing trac in each lane is required for proper conguration. Light
or sporadic trac may result in slower congurations.
Lane Conguration – Automatic
Follow the steps below to automatically congure lanes in SmartSensor
Manager:
Select 1 Edit>Lane Conguration.
Once the Lane Conguration page opens, click on the 2 Automatic buon.
If you would like to set constraints on the conguration through the 3 Edit
Range Blinders or Manage Gain buons, do so now. For more information
on these options see the sections on them in the following pages.
Click the 4 Restart buon at the lower right.
Conrm the conguration restart by clicking 5 Yes in the box that appears
6
Lane Setup