User's Manual

64
CHAPTer 6 o LANE SETUP
No adjustments to the gain can be made once the conguration is saved to the
sensor. However, the detection thresholds congured for the sensor during the
automatic conguration process are based upon the current level of the gain and
will continue to adapt for up to one minute after clicking the Finished buon.
Note
The default starting point of 5 is also the largest starting point allowed. If
you enter a value larger than 5 the default starting point of 5 will be used. If
you are managing the gain, you should generally change the starting point
to a 3 or 4.
Lane Conguration – Manual
If the sensor is unable to automatically congure itself to your satisfaction, you
can manually congure it by adding, removing or adjusting lanes, lane dividers
and lane centers.
To make changes in Manual mode:
With the Lane Conguration page open, select the 1 Manual buon; the
buons in the toolbar on the right of the screen will change from gray to
black (see Figure 6.2).
Manual Lane CongurationFigure 6.2 –
Selecting a buon in the toolbar will allow you to make changes using the 2
roadview window on the left.