User's Manual

14
Figure 1.1 – Attach the Mount Bracket to the Pole
Attaching the Sensor to the Mount Bracket
Use the following steps to securely fasten the sensor to the mount bracket:
1. Align the bolts on the sensor’s back plate with the holes in the mount
bracket. The 8-pin connector receptacle at the bottom of the unit should be
pointing towards the ground.
2. Place the lock washers onto the bolts after the bolts are in the mount
bracket holes.
3. Thread on the nuts and tighten (see Figure 1.2)
Note
If you are mounting the sensor to the back side of the mast arm, you will
probably need to mount the sensor down toward the road. This will allow you to
use one swivel to point down towards the road and the other to pan left and
right.