User's Manual

35
Figure 2.8: Symbolic Representation of Click! 112 I/O Channel Mapping
By default the DIP switches of a Click! 112/114 will be set as seen in Figure 2.9.
On a two-channel card this default setting selects, Matrix output channels 1 & 2 for
output. To select channels 3 & 4 move switch 4 down and switch 3 up as shown in
Figure 2.10. To make the channels software configurable, set switches 1-4 down as
shown in figure 2.11
No load
S2 S3 S5
On
Off
1 2 3
4
5 6 7 8
1
2 3
4
5 6 7 8
Contact Type Switches Baud Rate Switches
Channel
1 & 2
Channel
3 & 4
Bus
1
Bus
2
No load
On a 2-channel card: selects Matrix channels 1 & 2 for output
Channel
Group
S4
Input Mapping Switches
On a 4-channel card: selects Matrix channels 1 through 4 for output
Figure 2.9 – Default Position of S4 – Input Mapping Switches