User's Manual

44
Figure 3.1 Wavetronix Configuration Toolkit
To attach portable system link:
1. Rock the Click! 421 DIN rail mounted device onto the green T-bus expansion
slot to the left of the gray T-bus connector.
2. Make a serial connection between the DIN rail mounted device and the
handheld. In the case of a wired connection, you will need to physically
connect the serial cable from the handheld device. You can add a USB
extension cable to increase the length of you run is necessary.
If you wish to establish a wired connection with a laptop computer instead of the
handheld device, use the laptop’s native RS-232 serial port to connect to the Click!
421. Or a USB-to-serial convertor if the laptop does not have an RS-232 serial port.
You may also wish to establish a Bluetooth connection from your laptop to the Click!
421. To do so, consult your laptop’s software guidelines on how to discover
Bluetooth devices and configure a Bluetooth serial connection.
Note
The Wavetronix Configuration Toolkit can also be used to configure
SmartSensor Advance, SmartSensor HD, and a host of Click! devices. For
example, the Toolkit also comes pre-loaded with Click! Supervisor to allow
software management of Click! 112/114 rack cards.