User's Manual

51
Communication
In this Chapter
 Serial Connection
 Internet Connection
 Virtual Connection
 Address Book
 Viewing Connection Information
 Uploading the Sensor’s Embedded Software
Once the SmartSensor Matrix units are installed, use the SSMMX software to
change settings, view data, and configure the sensors to the roadway.
First, connect your configuration computer to the Wavetronix Stop Bar Detection
System command and control bus. Next, launch SSMMX by either clicking on the
icon that was placed on your desktop or clicking the icon found in the Start menu.
The SSMMX main screen shown in Figure 4.1 will appear.
Figure 4.1 – SSMMX Main Screen (New Screenshot needed)