User's Manual

66
When on the Lanes & Stop Bar view there are three display options:
• Edit Area only
• Edit Area with Saved Configuration Overlay
• Edit Area with Automatic Configuration Overlay
Figure 6.1 shows the Edit Area only. The Edit Area shows changes that have been
made within SSMMX, but that have not yet been saved on the sensor. Figure 6.2
shows the Lanes and Stop Bars view with the Saved Configuration Overlay (left) and
the Automatic Configuration Overlay (right). To show or hide these overlays toggle
the
Saved Cfg and/or Auto Cfg buttons. These buttons are found below the sensor
view and above the menu bar.
SmartSensor Matrix is constantly running the auto-configuration process in order to
find undiscovered lanes and stop bars.
Figure 6.1 – Lanes & Stop Bars View with Overlays
The menu bar at the bottom of the screen will allow you to perform a variety of
operations during Sensor Setup. Press the yellow up-arrows icon at the right side of
Note
When on the Lanes & Stop Bars view, you only see vehicle tracks. These
tracks are not constrained to lanes, even after you have saved a lane
configuration to the sensor. Vehicle detections are only viewed on the
Verification View.