User's Manual

68
Restart Automatic Lane Configuration
When you enter the Sensor Setup screen for the first time, restart the auto-
configuration process to erase auto-configuration information that may have been
gathered before the sensor’s alignment was finalized.
To restart the automatic lane configuration process:
1. Click the Restart or Reboot button
2. Click OK on the Restart of Reboot popup window (see Figure 6.3).
Figure 6.3 – Restart or Reboot Popup
Capture Lanes and Stop Bars to Edit Area
When auto-configured lanes appear they can be captured by clicking on them.
Once a lane is captured it becomes part of the Edit Area. Captured lanes are not
saved to the sensor until after clicking on the
Save Config button.
To capture a single lane:
1. Click on the lane once to select it.
2. Click on the lane a second time to bring up the Capture pop-up window (see
Figure
3. Click on the Capture Lane button to capture the selected lane.
Figure 6.4 – Capture Popup
Each lane has its own stop bar. If a stop bar is found for a lane it will be captured
with the lane. If you want to capture all the configured lanes, press the
Capture All
button.
Make Manual Adjustments
If necessary the following manual adjustments can be made:
• Add / delete a lane
• Insert / delete a lane stop bar
• Move a lane stop bar
• Insert / delete a lane node
• Move a lane node
• Adjust the width of a lane node