User's Manual

71
Figure 6.9 – Example of an Invalid Lane Configuration
To adjust the width of a lane node:
1. Click in the Edit Area to select a lane.
2. Click on the selected lane in the vicinity of the desired node to bring up the
Edit Node popup (see Figure 6.8).
3. Click on the Width Edit Box up/down bumpers to change the width of the
node (in feet). Adjusting the node width will impact detection search area
for that lane.
To adjust thresholds:
1. Click on the Edit Thresholds Button.
2. Click within the sensor view. This will bring up the Sensitivity popup (see
Figure 6.10)
Figure 6.10 – Sensitivity Popup
3. If you wish to edit all sensor thresholds, click on the Adjust All button.
4. If you wish to reset all sensor thresholds to defaults, click on the Reset All
button.