User's Manual

73
Figure 6.13 – Setup Zones & Channels View
Figure 6.14 – Setup Zones & Channels Menu Bar
The Edit Zone button will allow you to move a zone, and also specify the channels to
which it is mapped. Use the arrows to move the zone. To move just one corner of a
zone, select the zone by clicking on it, and the click again on the desired node. Then
drag the zone to the desired location. Zones are allowed to overlap each other.
Click on the C1 through C4 LEDs to map the selected zone to the desired channels.
If the LED is green the zone will be mapped to that channel. If it is gray then it will
not be mapped.
Figure 6.15 – Edit Zone Button