User's Manual

74
The Zone/Channel Map will also allow you to map or un-map zones to channels (see
Figure 6.16). A zone is mapped to a channel if the corresponding LED is green.
Otherwise it is not mapped.
Figure 6.16 - Zone/Channel Map Popup
The Edit Channel popup will also allow you to map / un-map channels. Click on the
LEDs to configure the mapping. This popup also allows you to view and then edit
extend and delay settings for the selected channel (see Figure 6.17). To edit the
extend and delay, click in the white box with the E and D, and the corresponding edit
boxes will appear (see Figure 6.18).
Figure 6.17 – Edit Channel Popup
Figure 6.18 – Edit Extend Delay
The extend and delay settings can also be specified using the Output Settings popup
(Figure 6.19). This popup also allows you to specify the minimum pulse width. The
minimum pulse width is the minimum duration a presence detection will be
signaled via the contact closure rack cards. All these output settings are specified
in seconds.
Figure 6.19 – Output Settings Popup