User's Manual

90
Yellow
Manually configure BUS1 baud rate
Yellow Flashing
Manually configure BUS2 baud rate
Red Flashing
Reset configuration to factory defaults
None
Cancel and exit menu
Figure D.5 Front-panel software configuration modes
The Blue Flashing mode is used to select the input channels to map to the output
channels. This mode will display the input channel group, but not allow it to be
software configured unless the S4 DIP switch makes the channel group selection
software configurable. Figure D.2 shows them submenu LED patterns that
correspond to specific channel selections. While in the Blue Flashing Mode hold the
mode switch until the desired submenu LED pattern is displayed. Release the
button and then momentarily press it once again in order to finalize selection of the
input mapping. After selection of the channel group, the card will return to the
normal operating mode.
Submenu LED
Pattern
Click! 114
Click! 112
○○○●
Channels 1-4 Channels 1-2
○○●○
Channels 5-8 Channels 3-4
○○●●
Channels 9-12 Channels 5-6
○●○○
Channels 13-16 Channels 7-8
○●○●
Channels 17-20 Channels 9-10
○●●○
Channels 21-24 Channels 11-12
○●●●
Channels 25-28 Channels 13-14
●○○○
NA Channels 15-16
●○○●
NA Channels 17-18
●○●○
NA Channels 19-20
●○●●
NA Channels 21-22
●●○○
NA Channels 23-24
●●○●
NA Channels 25-26
●●●○
NA Channels 27-28
○○○○
Cancel menu and
exit
Cancel menu and
exit
Figure D.6- Blue Flashing Mode Submenu