User's Manual

92
○●○●
115200 bps
●●●●
Error
Figure D.8 – Baud Rate Encoding
The Yellow and Yellow Flashing modes are used to manually software-select the
baud rate for Bus 1 and Bus 2 respectively. Figure D.3 shows them submenu LED
patterns that correspond to specific auto-baud actions. While in either mode hold
the mode switch until the desired submenu LED pattern is displayed (see Figure
D.8). Release the button and then momentarily press it once again in order to
execute the desired action. If you wish to cancel and exit the menu without having
made a selection wait until the submenu LEDs are all blank (see Figure D.9).
Submenu LED
Pattern
Action
○○○○
Cancel menu and exit
Figure D.9 –LED Submenu Pattern to Cancel Menu and Exit
The Red Flashing mode is used to reset the sensor to software factory defaults.
Please note that the position of the DIP switches may override software factory
defaults.
The Click! Supervisor software runs on PC and Pocket PC platforms. To learn how to
install the Click! Supervisor software, contact Wavetronix Technical Services or
consult the Click! user documentation. To help you select an individual rack card on
a multi-drop bus, Supervisor will auto-discover the device ID, model number and
description. You may wish to enter into the description field information pertaining
to rack slot position and detected traffic direction. For example, you can enter “NB
traffic slot 2”. Select the rack card you want to configure from the list (see Figure
D.10) and then select the driver you wish to use to configure the card from the list of
available drivers.
Once you connect to the rack card, Supervisor will recommend to upgrade the
embedded software if a newer version is available. The code files for an upgrade
should be installed in the “Click Home\Drivers\112” and “Click Home\Drivers\114”
directories. Contact Wavetronix customer service if you have questions regarding
the code or driver files in these directories. The last three pairs of numbers in the
filename (before the .txt suffix) indicate the release date of the code: YY.MM.DD
(year.month.day).
Note
When the DIP switches control the baud rates, you the specified baud rate is
displayed in the menu, but cannot be changed.